![]() ![]() When working with pattern component families for divided surfaces in a mass, you can create a larger mullion panel family subdivided by smaller sub-panels. RFT afterward to set it back as a family template. If needed you could rename the extension back to. RFA, you can open the file normally and delete any of these elements. If you simply make a copy of the file, and rename the extension back to. When considered a template and you start a new family file from this template, the elements from the template will be locked from deletion. What if you need to delete these elements? Or simply take an existing family and rename the extension using the same process as above. RFT the elements you added in that file will now be locked from deletion if you create a new family from this template. How did the family get to this current state?īy default if you start a new family file, add some elements, save the family, navigate to the family file, and rename the extension from. You notice the Delete tool is grayed out you cannot delete these elements in the family. You are editing a family file and select elements to delete. Included below is a quick example video of the above scenario and two approaches for reference at the end take note how the orientation matches the floor plan angle: Then move the new instance down the orientation should match the original instance. Select the detail group instance > Copy > Paste Aligned to Same Place. The orientation should match the original instance. Hold the CTRL key > drag the detail group to create a copy. If you want to create a second instance matching the original detail group orientation, you can use one of the following tips: The new detail group instance should reflect the floor plan orientation the detail view resides in.Įven though the detail view was rotated, new instances of the detail group will reflect the host view orientation. Instead of the expected matching orientation of the existing group, it is inserted rotated. When in this detail view, you copy the existing detail group and paste it. At some point the callout or the crop region of the detail view is rotated changing the orientation. You have a Detail View which was added in a Floor Plan View. I want to outline the following scenario:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |